Welcome to the website of Dalian Barnet Flex Hydraulic Co., Ltd.!

搜索
Search
BNTFLEX @ WhatsApp

BNTFLEX Hotline
You can contact the BNTFLEX SERVICE Hotline at the phone number +8618322701295
Open Number directly in click here.

BNTFLEX SALES Hotline
You can contact the BNTFLEX SALES Hotline at the phone number+8618522290645
Open Number directly in WhatsApp click here.
imgboxbg

NEWS CENTER

Position:
Homepage
/
/
/
Scale and pressure adjustment method of hose crimping machine

Scale and pressure adjustment method of hose crimping machine

  • Categories:Company News
  • Author:
  • Origin:
  • Time of issue:2020-06-09
  • Views:0

(Summary description)Scale and pressure adjustment method of hose crimping machine

1. Ruler adjustment

The ruler is used to adjust the amount of withholding. Adjusting the amount of withholding clockwise decreases, and

Scale and pressure adjustment method of hose crimping machine

(Summary description)Scale and pressure adjustment method of hose crimping machine

1. Ruler adjustment

The ruler is used to adjust the amount of withholding. Adjusting the amount of withholding clockwise decreases, and

  • Categories:Company News
  • Author:
  • Origin:
  • Time of issue:2020-06-09
  • Views:0
Information
Scale and pressure adjustment method of hose crimping machine
 
1. Ruler adjustment
 
The ruler is used to adjust the amount of withholding. Adjusting the amount of withholding clockwise decreases, and adjusting the amount of withhold counterclockwise increases. The scale is connected with the end cap of the cylinder by three hex screws and three springs on the scale base. Use the hand to pull the scale (perpendicular to the direction of the end cap of the cylinder). It should be able to flexibly leave the end cap of the cylinder. Before each start-up, you should carefully check whether the scale expansion and contraction are flexible and the lead connection is reliable.
 
Turn the ruler's main ruler to within 0 lines of the auxiliary ruler, start the trial operation, and observe whether each action is normal. If the piston crawls when reciprocating, loosen the exhaust screw on the top of the cylinder to exhaust.
 
         2. Pressure adjustment
 
Withholding pressure and mold opening pressure are adjusted by the two knobs on the back of the cylinder (see figure), the pressure is adjusted clockwise to increase, and the pressure is adjusted counterclockwise to decrease (the pressure is adjusted at the factory).
 
Specific operation
 
According to the specifications of the withdrawn hose, select the appropriate mold to install on the mold base according to the crimp hose technical parameter reference table, and adjust the scale position according to the data in the table to crimp the hose. After crimping the tube, use a caliper to measure whether the outer diameter of the sleeve after crimping meets the data of the parameter reference table. If it does not match, fine-tune the scale until it meets the requirements. Due to different manufacturers of pipe sleeves, their specific sizes, materials, hardness, etc. are not the same, these factors will have different degrees of impact on the results of the crimp hose, therefore, the data in the table is for reference only, the detailed data is based on the pressure test.

Scan the QR code to read on your phone

CONTACT FORM

We’ll take the time to explain the recommended solution and its price

Username used for comment:
Customer message
Description:

BNTFLEX SOCIAL

pinterest
pinterest
twitter
twitter
facebook
Bntflex
youtube
youtube

CONTACT

Copyright © 2019 Dalian Barnett Flex Hydraulics Co.,Ltd.       辽ICP备20000203号

电话

邮箱

产品